* *
*
On page 191, at the end of Chapter 24 of A Discipline of Programming (Prentice-Hall, 1976) the following note should be added:
Note 3. In the program as published above, Mark Bebie has found an error. In order to maintain the convention:
| "set(i) = 2 and set(−i) | edge i is a processed edge of the clockwise boundary of the light cap" |
the values of set(i) and set(-i) have to be adjusted when edge i is processed, i.e. b:hiext(i) takes places. In "extend b and refresh xx" this has been done (in the third line), in "inspect face along −xx", however, it has erroneously been omitted. Its tenth line:
do b.dom = 0 → b:hiext(lumen * yy) od
should therefore be replaced by
do b.dom = 0 →
odb:hiext(lumen * yy);
set:(b.high)= 2; set:(−b.high)= 0
(End of note 3.)
* *
*
Two further corrections.
On page 159, line 21 from above
begin glocon N, to, lcr; glovar from, uvl, suv, min, h; privar len;
should be replaced by
begin glocon to, lcr; glovar from, uvl, suv, min, h; privar len;
On page 141, line 11 from above
x2 + y2 ≤ r and x2 + (y + 1)2 < r
should be replaced by
x2 + y2 ≤ r and x2 + (y + 1)2 > r
Edsger W. Dijkstra